Cisco Nexus 7000 Series Reference Manual page 216

filter frame-type arp
filter frame-type arp
To configure the Address Resolution Protocol (ARP) frame type filter for the Encapsulated Remote
Switched Port Analyzer (ERSPAN) session, use the filter frame-type arp command. To remove the
filter from the session, enter the no form of this command.
Syntax Description
arp-rarp
arp
rarp
req-resp
req
resp
sender-ip
ip-address
target-ip
ip-address
Defaults None
Command Modes
config-erspan-src mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.2(2)
Usage Guidelines
This command does not require a license.
Examples This example shows how to configure the ARP frame type filter for the ERSPAN session:
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# filter frame-type arp arp-rarp arp
Cisco Nexus 7000 Series NX-OS System Management Command Reference
188
filter frame-type arp [arp-rarp [arp | rarp] [req-resp [req | rsp]] [sender-ip ip-address]
[target-ip ip-address]]
no filter frame-type arp [arp-rarp [arp | rarp] [req-resp [req | rsp]] [sender-ip ip-address]
[target-ip ip-address]]
(Optional) Specifies an ARP or Reverse Address Resolution Protocol (RARP)
frame type filter.
(Optional) Specifies an ARP frame type filter.
(Optional) Specifies an RARP frame type filter.
(Optional) Specifies a filter based on a request or response.
(Optional) Specifies a filter based on a request.
(Optional) Specifies a filter based on a response.
(Optional) Specifies a filter based on a sender IP address.
(Optional) Specifies a filter based on a target IP address.
Modification
This command was introduced.
F Commands
OL-25806-03