Cisco Nexus 7000 Series Reference Manual page 50

blink
blink
To blink the LED on the system, use the blink command. To restore the default LED state, use the no
form of this command.
Beginning with Cisco NX-OS Release 4.1(2), the blink command is not available in Cisco NX-OS
Note
software. Use the locator-led command for this function.
Syntax Description chassis
fan f-number
module slot
powersupply
ps-number
xbar x-number
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
4.0(1)
Usage Guidelines Use the blink command to flash the LED on a component in the system. You can use this blinking LED
to identify the component to an administrator in the data center.
This command does not require a license.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
22
blink {chassis | fan f-number | module slot | powersupply ps-number | xbar x-number}
no blink {chassis | fan f-number | module slot | powersupply ps-number | xbar x-number}
Blinks the chassis LED.
Blinks the LED that represents the configured fan number. The range depends on
the platform. Use ? to see the range.
Blinks the module LED. The range depends on the platform. Use ? to see the
range.
Blinks the power supply LED. The range depends on the platform. Use ? to see
the range.
Blinks the xbar module LED. The range depends on the platform. Use ? to see the
range.
Modification
This command was introduced.
B Commands
OL-25806-03