Snmp-Server Host Filter-Vrf - Cisco Nexus 7000 Series Reference Manual

S Commands

snmp-server host filter-vrf

To configure a Simple Network Management Protocol (SNMP) host receiver to gather notifications that
occur on a specific virtual routing and forwarding (VRF) instance, use the snmp-server host filter-vrf
command. To remove the VRF filter, use the no form of this command.
Syntax Description
host-address
vrf-name
udp-port port
Defaults
None
Command Modes Global configuration mode
Command History Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure the host receiver to receive notifications from the red VRF.
switch# config terminal
switch(config)# snmp-server host 10.1.1.1 filter-vrf red
Related Commands Command
show snmp
snmp-server host
snmp-server host
use-vrf
OL-25806-03
snmp-server host host-address filter-vrf vrf-name [udp-port port]
no snmp-server host host-address filter-vrf vrf-name [udp-port port]
Name or IP address of the host (the targeted recipient).
Name of the VRF. The name can be any alphanumeric string up to 63
characters.
(Optional) Specifies the port UDP port of the host to use. The range is from
0 to 65535. The default is 162.
Modification
This command was introduced.
Description
Displays SNMP information.
Configures an SNMP host receiver.
Configures Cisco NX-OS to send notifications on the specified VRF to
communicate with an SNMP host receiver.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
snmp-server host filter-vrf
385