Rmon Hcalarm - Cisco Nexus 7000 Series Reference Manual

rmon hcalarm

rmon hcalarm
To configure a 64-bit RMON high-capacity alarm (hcalarm), use the rmon hcalarm command. To delete an
rmon hcalarm, use the no form of this command.
Syntax Description alarm-number
mib-object
sample-interval
absolute
delta
rising-threshold
-high value
rising-threshold-
low value
rising-event
falling-threshold-
high value
falling-threshold-
low value
falling-event
owner
alarm-owner
Defaults None
Command Modes Global configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
4.0(1)
Cisco Nexus 7000 Series NX-OS System Management Command Reference
358
rmon hcalarm alarm-number mib-object sample-interval {absolute | delta} {rising-threshold-
high value rising-threshold-low value [rising-event] [falling-threshold-high value
falling-threshold-low value [falling-event]]} [owner alarm-owner]
no rmon hcalarm alarm-number
RMON hcalarm number. The range is from 1 to 65535.
MIB object to monitor. The maximum length is 80 alphanumeric characters.
Sample interval in seconds. The range is from 1 to 700000.
Specifies to test each sample directly.
Specifies to test the difference (delta) between the current and previous sample.
Configures the upper 32 bits of the 64-bit rising threshold value. The range is from
0 to 4294967295.
Configures the lower 32 bits of the 64-bit rising threshold value. The range is from
0 to 4294967295.
(Optional) Event to trigger on rising threshold crossing. The range is from 0 to
65535.
Configures the upper 32 bits of the 64-bit falling threshold value. The range is
from 0 to 4294967295.
Configures the lower 32 bits of the 64-bit falling threshold value. The range is
from 0 to 4294967295.
(Optional) Event to trigger on a falling threshold crossing. The range is from 0 to
65535.
(Optional) Specifies an owner for the alarm. The maximum size is 80
alphanumeric characters.
Modification
This command was introduced.
R Commands
OL-25806-03