Event Fanbad - Cisco Nexus 7000 Series Reference Manual

E Commands

event fanbad

To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of a
fan bad event, use the event fanbad command. To remove the fan bad event criteria, use the no form of
this command.
Syntax Description
fan number
time interval
Defaults
None
Command Modes Embedded event manager
Supported User Roles network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to specify that an EEM applet runs when a fan bad event occurs:
switch# configure terminal
switch(config)# event manager applet bad-applet
switch(config-applet)# event fanbad time 42
switch(config-applet)#
OL-25806-03
event fanbad [fan number] time interval
no event fanbad [fan number] time interval
(Optional) Specifies a fan number to monitor for a fan bad event. The range is
from 1 to 4.
Specifies the time interval (in seconds) within which the fan can stay bad. The
range is from 0 to 4294967295.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
event fanbad
147