Diagnostic Monitor Module - Cisco Nexus 7000 Series Reference Manual

diagnostic monitor module

diagnostic monitor module
To configure a diagnostic monitor test, use the diagnostic monitor module command. To remove a
diagnostic monitor test, use the no form of this command.
Syntax Description module
test
all
name
test-id
Defaults None
Command Modes
Global configuration mode (config)
Supported User Roles network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to configure a diagnostic monitor test:
switch(config)# diagnostic monitor module 1 test all
switch(config)#
This example shows how to remove a diagnostic monitor test:
switch(config)# no diagnostic monitor module 1 test all
switch(config)#
Cisco Nexus 7000 Series NX-OS System Management Command Reference
124
diagnostic monitor module module test {all | name | test-id}
no diagnostic monitor module module test {all | name | test-id}
Module number.
Specifies a diagnostic test selection.
Specifies all test IDs.
Test name. The maximum number of characters is 32.
Test ID number.
Modification
This command was introduced.
D Commands
OL-25806-03