Ptp Vlan - Cisco Nexus 7000 Series Reference Manual

P Commands

ptp vlan

To configure the Precision Time Protocol (PTP) VLAN value on an interface, use the ptp vlan command.
To remove the PTP VLAN value from an interface, use the no form of this command.
Syntax Description vlan-number
Defaults
1
Command Modes Interface configuration mode (config-if)
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines Make sure that you are in the correct virtual device context (VDC). To change the VDC, use the switchto
vdc command.
Make sure that you have globally enabled PTP on the device and configured the source IP address for
PTP communication.
This command does not require a license.
Examples
This example shows how to configure the PTP VLAN value on an interface:
switch# configure terminal
switch(config)# interface ethernet 5/5
switch(config-if)# ptp vlan 9
switch(config-if)#
This example shows how to remove the PTP VLAN value from an interface:
switch(config)# interface ethernet 5/5
switch(config-if)# no vlan 9
OL-25806-03
ptp vlan vlan-number
no ptp vlan vlan-number
VLAN number. The range is from 1 to 4094.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
ptp vlan
343