Match (Netflow - Cisco Nexus 7000 Series Reference Manual

match (NetFlow)

match (NetFlow)
To specify match criteria for Flexible NetFlow flow records, use the match command. To remove match
criteria for flow records, use the no form of this command.
Syntax Description flow direction
interface input
interface output
ip protocol
ip tos
ipv4 destination
address
ipv4 source address
transport
destination-port
transport source-port
Defaults
No matching criteria are specified by default.
Command Modes Flow record configuration
Supported User Roles network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines A Flexible NetFlow flow record must be enabled before you can use the match command.
This command does not require a license.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
266
match {flow direction | interface {input | output} | ip {protocol | tos} | ipv4 {destination address
| source address} | transport {destination-port | source-port}}
match {flow direction | interface {input | output} | ip {protocol | tos} | ipv4 {destination address
| source address} | transport {destination-port | source-port}}
Specifies the direction of the flow to be matched.
Specifies that the match criterion is based on the input interface.
Specifies that the match criterion is based on the output interface.
Specifies that the match criterion is based on protocol.
Specifies that the match criterion is based on type of service (ToS).
Specifies that the match criterion is based on the destination IPv4 address.
Specifies that the match criterion is based on the source IPv4 address.
Specifies that the match criterion for transport layer fields is based on the
destination port.
Specifies that the match criterion for transport layer fields is based on the
destination port.
Modification
This command was introduced.
M Commands
OL-25806-03