Destination Interface (Span - Cisco Nexus 7000 Series Reference Manual

D Commands

destination interface (SPAN)

To add a destination interface to an Ethernet Switched Port Analyzer (SPAN) session for analyzing
traffic between ports, use the destination interface command. To remove the destination, use the no
form of this command.
Syntax Description
ethernet number
port-channel
number
Defaults
None
Command Modes
Monitor configuration (config-monitor)
Supported User Roles network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to add a destination to a SPAN session:
switch# configure terminal
switch(config)# monitor session 3
switch(config-monitor)# destination interface ethernet 2/5, ethernet 3/7
Related Commands Command
monitor session
OL-25806-03
destination interface {ethernet number | port-channel number}
no destination interface {ethernet number | port-channel number}
Specifies the destination Ethernet interface slot number for the specified SPAN
session. Source packets are copied from this destination. The range is from 1
through 10.
Specifies the destination port channel interface for the specified SPAN session.
Source packets are copied from this destination. The range is from 1 through
4096.
Modification
This command was introduced.
Description
Places you into the Monitor configuration mode for configuring a SPAN
session.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
destination interface (SPAN)
107