Action Forceshut - Cisco Nexus 7000 Series Reference Manual

action forceshut

action forceshut
To configure a forced shutdown of a module, a crossbar ASIC, or the entire switch when an Embedded
Event Manager (EEM) applet is triggered, use the action forceshut command. To remove the forced
shutdown, use the no form of this command.
Syntax Description
label
module module
xbar xbar-number (Optional) Forces a shutdown of the specified crossbar ASIC. The ASIC range is
reset-reason string Provides a string that is enclosed in double quotation marks to explain the reason
Defaults
None
Command Modes Embedded event manager
Supported User Roles network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to configure a forced shutdown of module 4 when an EEM applet is triggered:
switch# configure terminal
switch(config)# event manager applet forceshut-applet
switch(config-applet)# action 1.3 forceshut module 4 reset-reason "module 4 failed"
switch(config-applet)#
Cisco Nexus 7000 Series NX-OS System Management Command Reference
10
action label forceshut [{module module | xbar xbar-number}] reset-reason string
no action label forceshut [{module module | xbar xbar-number}] reset-reason string
Unique identifier that can be any string value. Actions are sorted and run in an
ascending alphanumeric sequence using the label as the sort key. If the string
contains embedded blanks, enclose it in double quotation marks.
(Optional) Forces a shutdown of the specified module. The module range is from
1 to 10.
from 1 to 5.
for a forced shutdown.
Modification
This command was introduced.
A Commands
OL-25806-03