Show Rmon - Cisco Nexus 7000 Series Reference Manual

Show Commands

show rmon

To display the configuration or onboard logs, use the show rmon command.
Syntax Description
alarms
events
hcalarms
logs
status
Defaults
None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to display the configured RMON alarms:
switch# show rmon alarms
Alarm 20 is active, owned by test
Monitors 1.3.6.1.2.1.2.2.1.16.30 every 30 second(s)
Taking delta samples, last value was 17
Rising threshold is 15, assigned to event 1
Falling threshold is 0, assigned to event 0
On startup enable rising or falling alarm
This example shows how to display the configured RMON events:
switch# show rmon events
Event 4 is active, owned by administrator@london_op_center
Description is WARNING(4)
Event firing causes log and trap to community public, last fired 03:32:43
This example shows how to display the configured high-capacity RMON alarms:
OL-25806-03
show rmon {alarms | events | hcalarms | logs | status}
Displays the configured 32-bit RMON alarms.
Displays the configured RMON events.
Displays the configured 64-bit HC (High Capacity) RMON alarms.
Displays the RMON event log.
Displays the RMON information.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
show rmon
617