Ethernet Setting - Mitsubishi Electric GT1685 Connection Manual

POINT POINT POINT
Example of [Detail setting].
For examples of [Detail setting], refer to the following.
17.4 PLC Side Settings

17.3.3 Ethernet setting

Item Description
The host is displayed. (The host is
Host
indicated with an asterisk (*))
Set the network No. of the connected
N/W No. Ethernet module.
(Default: blank)
Set the station No. of the connected
*1
Ethernet module.
PLC No.
(Default: blank)
Set the type of the connected
*1
Ethernet module.
Type
CRnD-70(fixed)
Set the IP address of the connected
IP address Ethernet module.
(Default: blank)
Set the port No. of the connected
Port No. Ethernet module.
(Default: 5001)
Communication UDP (fixed)
*1 Select [CRnD-700] for [Controller Type].
*2 Each of [GOT PLC No.] set in the communication detail
setting and [PLC No.] set in the Ethernet setting must be set
to different station numbers.
17.3.2 Communication detail settings
POINT POINT POINT
(1) Example of [Ethernet]
For examples of [Ethernet], refer to the following.
17.4 PLC Side Settings
(2) Communication interface setting by Utility
The communication interface setting can be
changed on the Utility's [Communication Settings]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GT User's Manual
(3) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
17. ROBOT CONTROLLER CONNECTION
17.3 GOT Side Settings
17
18
Range
―
19
1 to 239
1 to 64
CRnD-70(fixed)
20
0.0.0.0 to
255.255.255.255
1024 to 65534
UDP (fixed)
21
22
23
17 - 5