Mitsubishi Electric GT1685 Connection Manual page 842

4.
Double-click [GOT] of the CPU side I/F to display
[CPU side I/F Detailed Setting of GOT].
5.
Mark the [via GOT(Ethernet) transparent mode]
checkbox on the [CPU side I/F Detailed Setting of
GOT] screen.
6.
By clicking [Set], the [GOT (Ethernet) Transparent
Setting] is displayed.
Here, set the C Controller module (Q Series)
(Q24DHCCPU-V), which is firstly connected via a
GOT.
7.
Specify the IP address for [IP address] same as the
IP address assigned to the C Controller module (Q
Series) (Q24DHCCPU-V).
8.
The screen returns to [Transfer Setup]. Click
[Connection Test] to check if Setting/Monitoring tool
for C Controller module has been connected to the
C Controller module (Q Series) (Q24DHCCPU-V).
23 - 80
23. FA TRANSPARENT FUNCTION
23.6 Personal Computer Side Setting

When connecting the GOT and personal
computer in Ethernet connection (GT16,
GT15, and GT14 only)
(1) When connecting the GOT and PLC in bus
connection
1.
Click the Connection Destination view
[Connection Destination]
data name)] in the Navigation window of MT Setting/
Monitoring tool for C Controller module.
2.
The [Transfer Setup] is displayed.
3.
Set the [Transfer Setup]:
PC side I/F : Ethernet Board
PLC side I/F : GOT
Other station : No specification
4.
Double-click [Ethernet Board] of the PC side I/F to
display [PC side I/F Ethernet Board Setting].
5.
Set the protocol to TCP. Network No. and Station
No. are not required to be changed (default)
because they are not used.
[(Connection target