Mitsubishi Electric GT1685 Connection Manual page 818

6.
Double-click [PLC module] of the PLC side I/F to
display [PLC side I/F Detailed setting of PLC module].
7.
On the [PLC side I/F Detailed setting of PLC module],
mark the [via GOT(Ethernet) transparent mode]
checkbox and click [Set].
8.
By clicking [Set], the [GOT (Ethernet) transparent
setting] is displayed.
Here, set the built-in Ethernet port QCPU or Ethernet
module, which is firstly connected via a GOT.
9.
Set [QnUDE(H)] or [QJ71E71] for [Type name].
When connecting the Q173NCCPU, set [QJ71E71].
10.
Specify the number for [Network No.] and [Station
No.] same as the number assigned to the Ethernet
module.
When [QnUDE(H)] is set for [Type name], the setting
is not required.
11.
Specify the IP address for [IP address] same as the
IP address assigned to the built-in Ethernet port
QCPU or Ethernet module.
23 - 56
23. FA TRANSPARENT FUNCTION
23.6 Personal Computer Side Setting
12.
The screen returns to [Transfer Setup]. Click
[Connection Test] to check if GX Developer has been
connected to the QCPU (Q mode).

Connecting the GOT and PLC in direct CPU
connection (when connecting to FXCPU)
1.
Click [Online] [Transfer Setup] in GX Developer.
2.
The [Transfer Setup] is displayed.
3.
Set the [Transfer Setup]:
PC side I/F : Serial
PLC side I/F : PLC module
Other station : No specification
4.
Double-click [Serial] of the PC side I/F to display [PC
side I/F Serial setting].