Mitsubishi Electric GT1685 Connection Manual page 468

(2) CC-Link Utility's [Parameter Settings]
(a) Parameter settings
*1
Item
Number of modules
Target module
Start I/O No.
Channel No.
Type
Mode
Expanded cyclic setting
Occupied number
Error event: input data
status
CPU stop: data link status
Other settings
All connect count
Sta.
Station Type
No.1
Expanded cyclic
Sta.
*2
No.1
setting
Sta.
*2
Occupied number
No.1
Sta.
Remote station points
No.1
Reserve/invalid Sta.
station select No.1
Intelligent buffer select
(word)
: Necessary
*1 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
13 - 28
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
13.4 PLC Side Setting
Setting
necessity at
Set value
GOT
connection
1
1
0000
H
(Use default value)
Master station
Remote net
(Ver.2 mode)
Single
Exclusive station 1
Clear
Refresh
(Use default value)
1
Ver.2 intelligent device
station
Single
Exclusive station 1
32 points
No setting
(Use default value)
: As necessary : Not necessary
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the C Controller
module (Q Series), either turn the C Controller module
(Q Series) OFF and then ON or reset it.

[Communication settings] of GT Designer3
Item
Station No.
Transmission Rate
Mode
Expanded Cyclic
Number of stations occupied
Input for Error Station
Retry
Timeout Time
Delay Time
POINT POINT POINT
[Controller Setting] of GT Designer3
For the setting method of [Controller Setting] of GT
Designer3, refer to the following.
13.3.1 Setting communication interface
(Communication settings)
Set value
1: Station No.1
0: Online 156kbps
Ver.2: Remote net (Ver.2 mode)
Single
1 Station
Clear
3times (Use default value)
3sec (Use default value)
0ms (Use default value)