Mitsubishi Electric GT1685 Connection Manual page 313


[Module parameter] of GX Works3
(1) Module parameter of Ethernet module (MELSEC iQ-
*1
R Series)
*1 Set [Module parameter] of the port under [Module
information].
Item
IP Address
Subnet Mask
Default Gateway
Setting Method of Network
Do Not Use IP Address
No. and Station No.
*2
Network No.
*3
Station No.
Transient Transmission
Group No.
Online Program Change
Permission/Protection
(Use default value)
Setting
Communication Data Code
Open Method Setting
Target Device Connection
Configuration Setting
: Necessary
*2 Set the same network No. as that of the GOT.
*3 Do not set the same station No. as that of the GOT.
Setting
necessity at
Set value
GOT
connection
192.168.3.19
-
-
1
2
Refer to (2).
: As necessary : Not necessary
(2) Target Device Connection Configuration Setting
Item
Protocol
Open system
Host station port No.
POINT POINT POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again, or reset the
PLC CPU.
(3) Routing setting
Up to 238 [Target Station Network No.]s can be set.
However, the same target station network number
cannot be set twice or more (multiple times).
Therefore, the one that can access to other station from
the request source host GOT is 238 kinds of [Target
Station Network No.]s.
Item
Target Station network No.
Relay Station network No.
Relay station No.
8. ETHERNET CONNECTION
8.4 PLC Side Setting
Set value
(Use default value)
MELSOFT connection (fixed)
(Use default value)
Range
1 to 239
1 to 239
1 to 120
8 - 27
1
2
3
4
5
6
7
8