Mitsubishi Electric GT1685 Connection Manual page 382

(1) Station number setting switch
Station number
Description
setting switch
Station number
setting
(Station No.1)
: Necessary
*1 Do not set the same station No. as that of the GOT.
(2) Mode setting switch
Mode setting switch Description
Mode setting
(Online: 10Mbps)
: Necessary
POINT POINT POINT
When the switch setting has been changed
Turn the PLC CPU OFF then ON again, or reset the
PLC CPU.
10 - 14
10. MELSECNET/10 CONNECTION (PLC TO PLC NETWORK)
10.4 PLC Side Setting
Setting
necessity
Set value
at GOT
connection
1
*1
: As necessary : Not necessary
Setting
necessity
Set value
at GOT
connection
0 (fixed)
: As necessary : Not necessary

Parameter setting (when connecting to
MELSEC-Q or QS series)
(1) [Network parameter] of GX Developer
(a) Network parameter
Item
Network type
*1
Starting I/O No.
*2
Network No.
Total stations
Group No.
Mode
Network range assignment
Refresh parameters
Interrupt settings
Control station return setting
*3
Redundant settings
Interlink transmission
parameters
Routing parameters
: Necessary
*1 When using Q170MCPU, set it according to the system
configuration.
*2 Specify the same network No. as that of the GOT.
*3 Set it when the MELSECNET/H network module is used in
the redundant QnPRHCPU system.
Setting
necessity at
Set value
GOT
connection
MNET/10 mode
(Control station) (fixed)
0000
H
1
2
0 (fixed)
Online (fixed)
Refer to (b)
(Use default value)
Refer to (c)
: As necessary : Not necessary