Controller Setting] Of Gt Designer3 - Mitsubishi Electric GT1685 Connection Manual

(b) Routing parameter setting
Up to 64 [Transfer Network No.]s can be set.
However, the same transfer network number
cannot be set twice or more (multiple times).
Therefore, the one that can access to other station
from the request source host GOT is 64 kinds of
[Transfer Network No.]s.
Item
Transfer target network No.
Relay network No.
Relay station No.
POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the
request source GOT.
For the setting, refer to the following.
9.3.3 Routing parameter setting
9 - 16
9. MELSECNET/H CONNECTION (PLC TO PLC NETWORK)
9.4 PLC Side Settings
Range
1 to 239
1 to 239
1 to 120
9.4.4 [Controller Setting] of GT
Designer3
Item
Network Type
Network No.
Station No.
Mode Setting
Retry count
Timeout Time
Delay Time
Refresh Interval
Monitor Speed
POINT POINT POINT

[Controller Setting] of GT Designer3

For [Controller Setting], of GT Designer3, refer to the
following.
9.3.1 Setting communication interface
(Communication settings)
Set value
MNET/H mode
1: Network No.1
2: Station No.2
Online (auto. reconnection)
3times (Use default value)
3sec (Use default value)
0sec (Use default value)
1time (Use default value)
10Mbs