Connecting To Melsec-Q/L - Mitsubishi Electric GT1685 Connection Manual

12.4.3 Connecting to MELSEC-Q/L


System configuration
(Network Type: CC IE Field)
■ GT Designer3 [Communication setting] of System
configuration1 (Network Type: CC IE Field)
<GOT>
(Use the default value for settings other
than the following.)
CC-Link IE Field Network
<CC-Link IE Field Network module> *
(Use the default value for settings other than the following.)
Station No.
Mode
Network type
Network No.
Total stations
Network Configuration Settings :
■ [Network parameter] of GX Works2
*1 The CC-Link IE Field Network module is mounted on slot 0
of the base unit.
The start I/O No. of the CC-Link IE Field Network module is
set at [0].
POINT POINT POINT
When connecting to Q170MCPU
When connected to Q170MCPU, the start I/O No. of
the CC-Link IE Field Network module is set to "70".
12 - 16
12. CC-Link IE FIELD NETWORK CONNECTION
12.4 PLC Side Setting
RX/RY00 to FFH
RW RW 00 to FFH
W/ r
1
: 0 (fixed)
: Online (normal)
: CC IE Field (Master station)
: 1
: 1
RX/RY00 to FFH
H
RW RW 00 to FFH
W/ r H

Parameter settings (Connection to MELSEC-
Q, QS series) of System configuration
(Network Type: CC IE Field)
(1) Network parameter] of GX Works2
Use GX Works2 of Version 1.31H or later.
(a) Network parameter
Item
Network type
*1
Starting I/O No.
*2
Network No.
Total stations
Station No.
*3
Mode
Network Configuration
Settings
Refresh parameters
Interrupt settings
Interlink transmission
parameters
Routing parameters
: Necessary
*1 When using Q170MCPU, set it according to the system
configuration.
*2 Specify the same network No. as that of the GOT.
*3 Set the same mode setting as that of the GOT.
Setting
necessity at
Set value
GOT
connection
CC IE Field
(Master station) (fixed)
0000
H
1
1
0 (fixed)
Online
(Normal mode)
Refer to (b)
(Use default value)
Refer to (c)
: As necessary : Not necessary