Connection To C Controller Module (Melsec Iq-R Series) - Mitsubishi Electric GT1685 Connection Manual


GT Designer3 [Communication settings] of
System configuration (Network Type: CC IE
Field)
Item
Network Type
Network No.
Station No.
Group No.
Mode Setting
Refresh Interval
Input for Error Station
Retry
Timeout Time
Delay Time
Monitor Speed
POINT POINT POINT
[Controller Setting] of GT Designer3
For the setting method of [Controller Setting] of GT
Designer3, refer to the following.
11.3.1 Setting communication interface
(Communication settings)
Set value
CC IE Field
1: Network No.1
1: Station No.1
0 (fixed)
Online
25ms (Use default value)
Clear (Use default value)
3times (Use default value)
3sec (Use default value)
0ms (Use default value)
High (Normal) (Use default value)
12. CC-Link IE FIELD NETWORK CONNECTION
12.4.2 Connection to C Controller
module (MELSEC iQ-R
Series)
This section describes the settings of the GOT and C
Controller module (MELSEC iQ-R Series) in the following
case of system configuration.
Use CW Configurator for the C Controller module
(MELSEC iQ-R Series) communication settings.

System configuration
(Network Type: CC IE Field)
■ System configuration (Network Type: CC IE Field)
<GOT>
(Use the default value for settings other
than the following.)
CC-Link IE Field Network
<CC-Link IE Field Network module> *
(Use the default value for settings other than the following.)
Station No.
Mode
Network type
Network No.
Total stations
Network Configuration Settings :
(1) [Module parameter] of CW Configurator
*1 The CC-Link IE Field Network module is mounted on slot 0
of the base unit.
The Start I/O No. of the CC-Link IE Field Network module is
set at "0".
12.4 PLC Side Setting
RX/RY00 to FFH
RW RW 00 to FFH
W/ r
1
: 0 (fixed)
: Online (normal)
: CC IE Field (Master station)
: 1
: 1
RX/RY00 to FFH
H
RW RW 00 to FFH
W/ r H
12 - 13
9
10
11
12
13
14
15
16