Configuring An Allowed-Active List Of Vsans - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 24 Configuring Trunking
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 24-8
Switch 1
VSAN1
VSAN2
VSAN3
VSAN4
VSAN5

Configuring an Allowed-Active List of VSANs

To configure an allowed-active list of VSANs for an interface using Fabric Manager, follow these steps:
Expand Interfaces and then select FC Physical.
Step 1
You see the interface configuration in the Information pane.
Click the Trunk Config tab.
Step 2
You see the current trunk configuration.
Set Allowed VSANs to the list of allowed VSANs for each interface that you want to configure.
Step 3
Click Apply Changes to save these changes or click Undo Changes to discard any unsaved changes.
Step 4
Default Settings
Table 24-4
Table 24-4
Parameters
Switch port trunk mode
Allowed VSAN list
OL-17256-03, Cisco MDS NX-OS Release 4.x
Operational and Allowed VSAN Configuration
lists the default settings for trunking parameters.
Default Trunk Configuration Parameters
Switch 2
VSAN1
VSAN2
VSAN3
Switch 3
VSAN1
VSAN2
VSAN4
VSAN5
Default
ON on non-NPV and MDS core switches.
OFF on NPV switches.
1 to 4093 user-defined VSAN IDs.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Default Settings
24-11