Configuring The Initiator Version - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Optional IKE Parameter Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 44-11
Select the Global tab.
Step 2
You see the global statistics of a specific IKE protocol in the Information pane (see
Figure 44-12
Enter a value (in seconds) in the KeepAliveInterval (sec). the The keepalive interval in seconds is used
Step 3
by the IKE entity on the managed device with all the peers for the DOI corresponding to this conceptual
row.
Click Apply Changes to save your changes.
Step 4

Configuring the Initiator Version

To configure the initiator version using Fabric Manager, follow these steps:
Step 1 Expand Switches > Security and then select IKE.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
44-18
IKE Configuration
IKE Global Tab Information
Chapter 44 Configuring IPsec Network Security
Figure
OL-17256-03, Cisco MDS NX-OS Release 4.x
44-12).