Chapter 30
Configuring and Managing Zones
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Select the members you want to add from the Fabric pane (see
Step 3
click the zone where you want to add members and click the Insert icon.
You see the Add Member to Zone dialog box shown in
Figure 30-14
Note
Click the browse button and select a port name or check the LUN check box and click the browse button
Step 4
to configure LUNs.
Click Add to add the member to the zone.
Step 5
Note
Zone Sets
This section describes zone sets and includes the following topics:
•
•
•
•
•
OL-17256-03, Cisco MDS NX-OS Release 4.x
Add Member to Zone Dialog Box
The Device Alias radio button is visible only if device alias is in enhanced mode. For more
information, see
"Creating a Device Alias" section on page
When configuring a zone member, you can specify that a single LUN has multiple IDs depending
on the operating system. You can select from six different operating systems.
About Zone Set Creation, page 30-16
Activating a Zone Set, page 30-17
Displaying Zone Membership Information, page 30-20
About the Default Zone, page 30-20
Configuring the Default Zone, page 30-21
Figure
Figure
30-14.
31-6.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Zone Sets
30-13) and click Add to Zone or
30-15