Deactivating A Zoneset - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Zone Sets
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 30-18
Check the Save Running to Startup Configuration check box to save all changes to the startup
Step 6
configuration.
Click Continue Activation to activate the zone set, or click Cancel to close the dialog box and discard
Step 7
any unsaved changes.
You see the Zone Log dialog box, which shows if the zone set activation was successful (see
Figure
Figure 30-19

Deactivating a Zoneset

To deactivate an existing zone set, follow these steps:
Step 1 Right-click the zone set you want to deactivate and then click Deactivate from the pop-up menu.
You see the Deactivate Zoneset dialog box as shown in
Cisco MDS 9000 Family Fabric Manager Configuration Guide
30-18
Save Configuration Dialog Box
30-19).
Zone Log Dialog Box
Chapter 30 Configuring and Managing Zones
Figure 30-20.
OL-17256-03, Cisco MDS NX-OS Release 4.x