Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 336

Using the Server Admin FlexAttach Wizards
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Repeat Step 3 through Step 4 for each switch.
Step 5
Click the PWWN to vPWWN tab to configure pWWN to vPWWN mapping.
Step 6
The Advanced Configuration window is displayed.
Figure 14-13
From the Select Switch drop-down list, select the switch to display the existing pWWN to Virtual
Step 7
PWWN mapping table for the CFS region to which the switch belongs, and then follow these steps to
add vPWWN to vPWWN automap entries:
a. Click Add Row to display the PWWN to vPWWN dialog box.
b. Enter the pWWN and the corresponding virtual pWWN.
Click Create to add the mapping list.
c.
Note
Click Finish to complete the configurations for each port.
Step 8
Cisco MDS 9000 Family Fabric Manager Configuration Guide
14-14
Pre-Configure Server - PWWN to vPWWN Configuration
To delete an existing mapping, select the row, and then click Delete Row. Only one pWWN to
vPWWN table can be updated at a time. To update the table for each CFS region, perform
Step 6 though Step 8 for a switch from each CFS region.
Chapter 14 Configuring FlexAttach Virtual pWWN
(Figure 14-13)
OL-17256-03, Cisco MDS NX-OS Release 4.x