Displaying Ficon Information - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Displaying FICON Information

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 36-29
Click Add to enter the source and destination(s) flows.
Step 2
Enter source and destination using 2 byte hex (by domain and area IDs).You can copy and paste these
Step 3
IDs, and then edit them if required.
Enter (or select) the number of ISLs between the two switches (for example, between domain ID 0a and
Step 4
0b).
Select a row to remove it and click Remove.
Step 5
Select the module for which you are calculating the load balance.
Step 6
Click Calculate to show the recommended topology.
Step 7
Note
Displaying FICON Information
This section includes the following topics:
•
•
•
•
Cisco MDS 9000 Family Fabric Manager Configuration Guide
36-40
Flow Load Balance Calculator
If you change flows or ISLs, you must click Calculate to see the new recommendation.
Receiving FICON Alerts, page 36-41
Displaying FICON Port Address Information, page 36-41
Displaying IPL File Information, page 36-41
Viewing the History Buffer, page 36-41
Chapter 36 Configuring FICON
OL-17256-03, Cisco MDS NX-OS Release 4.x