Default Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
After a successful CFS commit, the merge will be successful.
Default Settings
Table 29-6
Table 29-6
Parameters
IVR feature
IVR VSANs
IVR NAT
QoS for IVR zones
Configuration distribution
Cisco MDS 9000 Family Fabric Manager Configuration Guide
29-34
If the failure is due to exceeding the maximum configuration limits in a fabric where the switches
are running more than one Cisco SAN-OS release, then either upgrade the switches running the
earlier release or reduce the number of IVR zones and IIVR zone members on the switches running
the more recent release to the earlier release limit (see
page 29-4).
If the failure is due to exceeding maximum limits in a fabric where all switches are running the same
Cisco SAN-OS release, identify the switch that has the correct configuration and perform a CFS
commit to distribute the IVR configuration (see the
page 29-12 and the"IVR Limits Summary" section on page
For other failures, resolve the error causing the merge failure on the switch that has the correct
configuration and perform a CFS commit to distribute the IVR configuration (see the
Individual AFIDs" section on page
lists the default settings for IVR parameters.
Default IVR Parameters
Chapter 29
the"IVR Limits Summary" section on
"Configuring Default AFIDs" section on
29-4).
29-12).
Default
Disabled.
Not added to virtual domains.
Disabled.
Low.
Disabled.
Configuring Inter-VSAN Routing
"Configuring
OL-17256-03, Cisco MDS NX-OS Release 4.x