Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 427

Chapter 20 Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Click Apply to activate the configuration.
Step 5
To enable port guard for multiple interfaces using the Device Manager, follow these steps:
Step 1 From the menu bar, select Interface > FC All.
You see the FC Interfaces configuration window.
Click the Port Guard tab and then select the port (see
Step 2
Figure 20-7
Step 3 Check the check box in the Enable column.
(Optional) Enter the Duration in seconds and NumFlaps. If the values are 0, the port goes into a down
Step 4
state even if the link flaps once. Otherwise, the link goes into a down state if the link flaps for the
NumFlaps times within the Duration (in seconds).
Step 5 Click Apply to activate the configuration.
To enable port guard for a single interface using the Device Manager, follow these steps:
Right-click the interface in the module panel, and then choose Configure from the menu.
Step 1
You see the Interface configuration window.
Click the Port Guard tab (see
Step 2
OL-17256-03, Cisco MDS NX-OS Release 4.x
Device Manager - Port Guard Tab
Figure 20-8).
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Fibre Channel Interfaces
Figure 20-7).
20-17