Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 725

Chapter 32 Configuring Fibre Channel Routing Services and Protocols
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 32-10
Click Create to create a static route.
Step 2
You see the Create Route dialog box shown in
Figure 32-11
Select the VSAN ID that for which you are configuring this route.
Step 3
Fill in the destination address and destination mask for the device you are configuring a route.
Step 4
Select the interface that you want to use to reach this destination.
Step 5
Select the next hop domain ID and route metric.
Step 6
Step 7 Select either the local or remote radio button.
Step 8 Click Create to save these changes, or click Close to discard any unsaved changes.
OL-17256-03, Cisco MDS NX-OS Release 4.x
Fibre Channel Static Route Configuration Dialog Box
Create Fibre Channel Route Dialog Box
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Figure 32-11.
FSPF Routes
32-13