Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 607

Chapter 28 Creating Dynamic VSANs
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 28-1
You see the Select Master Switch page.
Click the switch you want to be the master switch. This switch controls the distribution of the DPVM
Step 2
database to other switches in the fabric.
Click Next.
Step 3
You see the AutoLearn Current End Devices page.
(Optional) Click the Create Configuration From Currently Logged In End Devices check box if you
Step 4
want to turn on autolearning.
Click Next.
Step 5
You see the Edit and Activate Configuration page.
Step 6 Verify the current or autolearned configuration. Optionally, click Insert to add more entries into the
DPVM config database.
Click Finish to update the DPVM config database, distribute the changes using CFS, and activate the
Step 7
database, or click Cancel to exit the DPVM Setup Wizard without saving changes.
Figure 28-2
Select the switch you want to be the master switch. This switch controls the distribution of the DPVM
Step 8
database to other switches in the fabric.
Click Next.
Step 9
You see the AutoLearn Current End Devices page as shown in
OL-17256-03, Cisco MDS NX-OS Release 4.x
DPVM Wizard Icon
DPVM Setup Wizard: Select Master Switch
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Figure 28-3.
DPVM
28-3