Moving A Server To Another Port Or Switch - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 14 Configuring FlexAttach Virtual pWWN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Moving a Server to Another Port or Switch

Using the Move Server wizard, you can move a server to another port on the same NPV device or another
NPV device without changing the SAN. This is accomplished by moving the virtual pWWN to the new
port. No change is needed if FlexAttach was configured using the physical port WWN of the server to
the virtual port WWN mapping.
To move a server to a different port in the same switch, or in a different switch, follow these steps:
In the Fabric Manger window, select Tools > FlexAttach > Move Server.
Step 1
The Move Server wizard is displayed.
Figure 14-14
Step 2 In the Move Server window, click the Another Port on the Same Switch radio button or click the
Another Port on a Different Switch radio button.
Click Next.
Step 3
The Move Port window is displayed.
OL-17256-03, Cisco MDS NX-OS Release 4.x
(Figure
Move Server Wizard
(Figure
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Using the Server Admin FlexAttach Wizards
14-14)
14-15)
14-15