Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 333

Chapter 14 Configuring FlexAttach Virtual pWWN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 14-10
In the Basic Configuration window, check the check box to select one or more switches from the list of
Step 3
NPV switches in the fabric.
Check the Enable FlexAttach Auto on every port check box to enable FlexAttach on all the ports of
Step 4
all the selected switches.
(Optional) From the VSAN ID drop-down list, select a VSAN ID to assign the selected VSAN ID to all
Step 5
the ports.
Note
Click the Up or Down radio button to assign the selected interface status.
Step 6
Note
Click Finish to pre-configure the selected settings to all the ports on all the selected switches.
Step 7
The Configuration window is displayed with the finished message.
OL-17256-03, Cisco MDS NX-OS Release 4.x
Pre Configure Server - Basic Configuration
Only the set of VSANs to which all the selected switches belong are listed. If no VSAN ID is
selected, then the existing VSAN configuration is retained.
The status of only the F ports in the selected switches will be brought to up or down.
Using the Server Admin FlexAttach Wizards
(Figure
Cisco MDS 9000 Family Fabric Manager Configuration Guide
14-11)
14-11