Launching Fabric Manager Web Client - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 7 Fabric Manager Web Client
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Save this file.
Step 4
Restart Fabric Manager Web Client.
Step 5
If you restart Fabric Manager Server with SSL enabled, you must restart Fabric Manager Web Client. If
Note
you want to stop and restart Fabric Manager Server with SSL disabled, then you must restart Fabric
Manager Web Client.

Launching Fabric Manager Web Client

Before you can use Fabric Manager Web Client to monitor a switch, the service must be started on the
server you are connecting through. The browser does not have to be on the same workstation where
Fabric Manager Web Client is installed.
To launch Fabric Manager Web Client, follow these steps:
If you are on the same workstation where you installed Fabric Manager Web Client, then open your
Step 1
browser and in the Location field enter http://localhost:PORT. Enter your port number if you specified
a different port during installation. You can omit the port number if you used port 80 by default.
If you are on a different workstation from where you installed Fabric Manager Web Client, then open
your browser and in the Location field enter http://<yourServerAddress>:PORT, where
<yourServerAddress> is the address where you installed Fabric Manager Web Client, and PORT is 80
by default. Enter your port number if you specified a different port during installation.
Tip
You see the Fabric Manager Web Client Login dialog box shown in
bottom shows the Message of the Day from the server you logged into.
OL-17256-03, Cisco MDS NX-OS Release 4.x
port="443" minProcessors="5" maxProcessors="75"
enableLookups="true"
acceptCount="10" debug="0" scheme="https" secure="true">
<Factory className="org.apache.catalina.net.SSLServerSocketFactory"
clientAuth="false" protocol="TLS"
keystoreFile="C:\Program Files\Cisco Systems\MDS 9000\keystore"
keystorePass="changeit"/>
</Connector>
Choose Start > Control Panel > Administrative Tools > Services to verify that Fabric Manager
Web Client has started. To start Fabric Manager Web Client, use a browser to go to the location
of the service.
You can also view this information using the Admin > Status menu of the Fabric Manager Web
Client .
On a UNIX workstation, use the following command:
$ /usr/local/cisco_mds9000/bin/FMWebClient.sh status
Figure
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Launching Fabric Manager Web Client
7-2. The text field at the
7-7