Pre-Configuring Flexattach For Each Port Individually - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Using the Server Admin FlexAttach Wizards
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 14-11

Pre-Configuring FlexAttach for Each Port Individually

Using the Pre-Configure Server Advanced configuration wizard, you can set the following port
configurations for each port in one or more switches individually:
To pre-configure FlexAttach on each port individually, follow these steps:
In the Fabric Manger window, select Tools > FlexAttach > Pre-configure Server.
Step 1
The Pre-Configure Server window is displayed.
In the Pre-Configure Server window, click the Advanced radio button to configure FlexAttach on each
Step 2
port individually.
The Pre-Configure Server Advanced configuration window is displayed.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
14-12
Pre-Configure Server - Finish
Enable FlexAttach Auto on all ports.
–
Enable FlexAttach Auto or Manual on individual ports.
–
Set the virtual PWWN for ports where FlexAttach enabled Manually.
–
Set pWWN to vPWWN mapping.
–
– Set the default VSAN ID for each port.
– Set the Interface status for each port.
Chapter 14 Configuring FlexAttach Virtual pWWN
(Figure 14-9)
(Figure
OL-17256-03, Cisco MDS NX-OS Release 4.x
14-12)