Chapter 36
Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
•
Configuring Port Blocking
If you block a port, the port is retained in the operationally down state. If you unblock a port, a port
initialization is attempted. When a port is blocked, data and control traffic are not allowed on that port.
Physical Fibre Channel port blocks will continue to transmit an Off-line state (OLS) primitive sequence
on a blocked port.
Caution
You cannot block or prohibit the CUP port (0XFE).
If a port is shut down, unblocking that port does not initialize the port.
The shutdown/no shutdown port state is independent of the block/no block port state.
Note
To block or unblock port addresses in a VSAN using Device Manager, follow these steps:
Choose FICON > VSANs.
Step 1
Select a VSAN ID and click Port Configuration.
Step 2
You see the FICON Port Configuration dialog box for the selected VSAN (see
Figure 36-14
Step 3
Check the Blocked check box for the port that you want to block.
Step 4
Click Apply to save the changes.
OL-17256-03, Cisco MDS NX-OS Release 4.x
Viewing ESCON Style Ports, page 36-26
Port Prohibiting, page 36-26
Assigning a Port Address Name, page 36-27
About RLIR, page 36-27
Displaying RLIR Information, page 36-27
FICON Port Configuration Dialog Box
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Configuring FICON Ports
Figure
36-14).
36-25