Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 576

FC IDs
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Expand End Device in the Physical Attributes pane and select the FLOGI tab in the Information pane
Step 1
to obtain the port WWN (Port Name field) of the HBA (see
Figure 25-11
Note
Expand Switches > Interfaces and then select FC Physical from the Physical Attributes pane.
Step 2
Set the Status Admin drop-down menu to down for the interface that the HBA is connected to.
Step 3
This shuts down the HBA interface in the MDS switch.
Expand Fabricxx > VSANxx and then select Domain Manager.
Step 4
Click the Persistent Setup tab in the Information pane to verify that the FC ID feature is enabled (see
Step 5
Figure
Figure 25-12
If this feature is disabled, continue with this procedure to enable persistent FC ID.
If this feature is already enabled, skip to
Step 6 Check the Enable check box to enable the persistent FC ID feature in the Cisco MDS switch (see
Figure
Step 7 Select the Persistent FcIds tab and assign a new FC ID with a different area allocation in the FcId field.
In this example, we replace 00 with ee (see
Cisco MDS 9000 Family Fabric Manager Configuration Guide
25-20
FLOGI Database Information in Fabric Manager
Both FC IDs in this setup have the same area 00 assignment.
25-12).
Persistent FC ID Information in Fabric Manager
25-13).
Chapter 25
Figure
Step 7.
Figure 25-13).
Configuring Domain Parameters
25-11.
OL-17256-03, Cisco MDS NX-OS Release 4.x