Reloading A Switch; Power Cycling Modules - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Reloading Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•

Reloading a Switch

To reload a switch using Fabric Manager, follow these steps:
Do one of the following in the Logical Domains pane:
Step 1
•
•
•
Step 2 Expand Switches and select Hardware in the Physical Attributes pane.
You see a list of modules contained in the selected switches.
Click the Card Module Status tab.
Step 3
You see the information shown in
Figure 19-2
Step 4 Check the Reset check box in the row of the switch to reload.
Step 5 Click the Apply Changes icon.

Power Cycling Modules

To power cycle any module using Fabric Manager, follow these steps:
Do one of the following in the Logical Domains pane:
Step 1
•
•
•
Step 2 Expand Switches and select Hardware from the Physical Attributes pane.
Step 3 Click the Card Module Status tab.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
19-6
Power Cycling Modules, page 19-6
Click SAN to display a list of all switches in the SAN.
Click one of the fabrics to display a list of switches for that fabric.
Click a VSAN to display a list of switches for that VSAN.
Card Module Status Tab
Click SAN to display a list of all switches in the SAN.
Click one of the fabrics to display a list of switches for that fabric.
Click a VSAN to display a list of switches for that VSAN.
Figure 19-2.
Chapter 19 Managing Modules
OL-17256-03, Cisco MDS NX-OS Release 4.x