Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 945

Chapter 44 Configuring IPsec Network Security
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 44-6
Step 5 Click Next. In the Specify Tunnel Properties dialog, you see the TCP connection characteristics.
Set the minimum and maximum bandwidth settings and round-trip time for the TCP connections on this
Step 6
FCIP link. Click the Measure button to measure the round-trip time between the Gigabit Ethernet
endpoints.
Check the Enable Write Acceleration check box to enable FCIP write acceleration on this FCIP link.
Step 7
See the
Check the Enable Optimum Compression check box to enable IP compression on this FCIP link. See
Step 8
the "FCIP Compression" section on page
Click Next to configure the FCIP tunnel parameters.
Step 9
Set the Port VSAN for nontrunk/auto and allowed VSAN list for the trunk tunnel. choose a Trunk Mode
Step 10
for this FCIP link. See the
Click Finish to create this FCIP link or click Cancel to exit the FCIP Wizard without creating an FCIP
Step 11
link.
To verify that IPsec and IKE are enabled using Fabric Manager, follow these steps:
Expand Switches > Security and then select IPSEC in the Physical Attributes pane.
Step 1
You see the IPsec configuration in the Information pane in
OL-17256-03, Cisco MDS NX-OS Release 4.x
Enabling IPsec on an FCIP Link
"FCIP Write Acceleration" section on page
"Checking Trunk Status" section on page
48-29.
48-37.
Figure 44-7.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Configuring IPsec Using FCIP Wizard
48-17.
44-11