Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 767

Chapter 36 Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 36-8
Step 2 Select the switches you want to be in the VSAN.
Step 3 Enter a VSAN ID.
Step 4 Enter the name of the VSAN, if desired.
Select the type of load balancing, the interop value, and the administrative state for this VSAN.
Step 5
Check the FICON check box.
Step 6
Note
Check the option, if appropriate, to enable fabric binding for the selected switches.
Step 7
Check the All Ports Prohibited option if all ports in this VSAN are prohibited.
Step 8
Click Create to create the VSAN.
Step 9
Choose Tools > Device Manager to open Device Manager for each switch in the FICON VSAN.
Step 10
Click FC > VSANs.
Step 11
You see the VSAN dialog box (see
OL-17256-03, Cisco MDS NX-OS Release 4.x
Create VSAN Dialog Box
You cannot enable interop modes on FICON-enabled VSANs.
Figure 36-9).
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Configuring FICON
36-17