Activating A Manually Configured Ivr Topology - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Manual IVR Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 29-8
Step 2 Click the Local Topology tab to display the existing IVR topology.
Step 3 Click the Create Row icon to create rows in the IVR topology (see
Select the switch, switch WWN, and a comma-separated list of VSAN IDs for this topology.
Step 4
Click Create to create this new row.
Step 5
Click the Apply Changes icon to create the IVR topology.
Step 6
Repeat this configuration in all IVR-enabled switches or distribute using CFS.
Note
Transit VSANs are deduced based on your configuration. The IVR feature does not have an explicit
Tip
transit-VSAN configuration.

Activating a Manually Configured IVR Topology

After manually configuring the IVR topology , you must activate it.
Active IVR topologies cannot be deactivated. You can only switch to IVR topology automatic mode.
Caution
To activate the manually configured IVR topology using Fabric Manager, follow these steps:
Expand All VSANs and then select IVR in the Logical Domains pane.
Step 1
You see the IVR configuration in the Information pane.
Figure 29-9
Step 2 Click the Action tab to display the existing IVR topology.
Step 3 Check the Activate Local Topology check box (see
Cisco MDS 9000 Family Fabric Manager Configuration Guide
29-16
Local Topology Tab
Action Tab
Chapter 29 Configuring Inter-VSAN Routing
Figure 29-8).
Figure 29-9).
OL-17256-03, Cisco MDS NX-OS Release 4.x