Chapter 21
Configuring N Port Virtualization
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
After you click the Next button in Step 3 of 6, the wizard determines if you have selected all the
connected pairs. A warning message is displayed (See
that you have not selected and warns that they will be segmented after the NPV setup.
Note
•
NPV wizard does not detect ports that are in a channel group and that are not connected by ISLs.
The wizard does not configure any port in a Port Channel Group to F ports on the core switch. Port
channel grouping is not applicable to NPV devices. (See
Remove the port channel groups if you need to select those particular ports as F ports during the
•
setup. For more information, see the
Figure 21-15
OL-17256-03, Cisco MDS NX-OS Release 4.x
"Configuring Port Security" section on page
Port Channel Group Detected.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Figure
21-17), that lists all the connected pairs
Figure
21-15.)
Configuring NPV
46-1.
21-19