Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 154

Fabric Manager Client Quick Tour: Admin Perspective
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
• NPV
Data Mobility Manager
•
Port Channel—Creates PortChannels from selected ISL either manually or automatically.
•
DPVM Setup—Establishes dynamic port VSAN membership, enables autolearning, and activates
•
the DPVM database.
IP SAN
•
Security
•
• Install
Cisco MDS 9000 Family Fabric Manager Configuration Guide
5-16
Compact Flash Report—Automatically scans the fabric and generate a report that shows the
–
status of CompactFlash.
CFS Static Peer Setup—Manage the peer list used during CFS on NPV enabled switches. After
–
setting up the static peers list, the CFS discovery on the switches will be changed to static mode
for all peers in the list. Fabric Manager does not automatically update static peers list. You may
need to update the list using the CFS Static Peer Setup Wizard when a new switch is added to
the fabric.
Traffic Map Setup—Configures the list of external interfaces to the servers, and enabling or
–
disabling disruptive load balancing. Using Traffic Map Setup you can specify the external ports
that a server should use for traffic management.
Flex Attach Pre-Configure Server—Sets the port configurations for all the ports in a switch such
–
as enabling or disabling FlexAttach, setting the default VSAN ID, setting the interface status
etc.
– Flex Attach Move Server—Moves a server to another port on the same NPV device or another
NPV device without changing the SAN.
Flex Attach Replace Server—Replaces a failed server with a new server onthe same port
–
without changing the SAN.
Server Based—Performs server-based data migration.
–
Storage based—Performs storage-based data migration.
–
Server LUN Discovery—Performs LUN discovery to select the LUNs available for migration
–
and automates the session creation by matching the LUNs in the existing and new storage.
FCIP Tunnel—Creates FCIP links between Gigabit Ethernet ports. Enables Fibre Channel write
–
acceleration and IP compression
iSCSI Setup—Creates zones for iSCSI initiators and adds a VSAN to a target-allowed VSAN
–
list.
SAN Extension Tuner—Optimizes FCIP performance by generating either direct access
–
(magnetic disk) or sequential access (magnetic tape) SCSI I/O commands and directing such
traffic to a specific virtual target. This option is used to generate SCSI I/O commands (read and
write) to the virtual target based on your configured options.
Port Security—Prevents unauthorized access to a switch port in the Cisco MDS 9000 Family,
–
rejects intrusion attempts and reports these intrusions to the administrator.
– IP ACL—Creates an ordered list of IP filters in a named IPv4-ACL or IPv6-ACL profile using
the IPv4-ACL Wizard.
– License—Facilitate download and installation of licenses in selected switches in the fabric.
Software—Verifies image compatibility and installs software images on selected switches in the
–
fabric.
Chapter 5 Fabric Manager Client
OL-17256-03, Cisco MDS NX-OS Release 4.x