Making A Port Eligible For A License - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 11 On-Demand Port Activation Licensing
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 11-5
Step 2 Click the Port Licensing tab.
You see the licenses that are in use as shown in
Figure 11-6
Step 3 Click Close to close the dialog box.

Making a Port Eligible for a License

By default, all ports are eligible to receive a license. However, if a port has already been made ineligible
and you prefer to activate it, then you must make that port eligible
The dialog box shown in Figure 11-7 applies only to the Cisco MDS 9124 Fabric Switch.
Note
To make multiple ports eligible to acquire a license using Device Manager, follow these steps:
Choose Interface > FC All and click the License tab or hold down the Control key, and then click each
Step 1
port that you want to make eligible.
Right-click the selected ports, select Configure, and click the License tab.
Step 2
You see the FC Interfaces dialog box as shown in
OL-17256-03, Cisco MDS NX-OS Release 4.x
Licenses Dialog Box
Licenses in Use
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Configuring Port Activation Licenses
Figure 11-6.
Figure 11-7.
11-5