Using The Software Install Wizard - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Using the Software Install Wizard

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Using the Software Install Wizard
You can use the Software Install Wizard to install Cisco NX-OS images on supported switches.
The Software Install Wizard supports installation and upgrade for Cisco MDS 9020 Fabric Switch or
Note
Cisco FabricWare. For successful installation and upgrade, specify the TFTP server address that the
Cisco MDS 9020 Fabric Switch should use.
Before you use this wizard, be sure the standby supervisor management port is connected.
Note
To use the Software Install Wizard, follow these steps:
Click the Software Install Wizard icon in the toolbar (see
Step 1
Figure 15-2
You see the Select Switches dialog box with all switches selected by default.
Figure 15-3
Deselect the check box for the switch(es) for which you do not want to install images on. You must have
Step 2
at least one switch selected to proceed (see
Click Next when finished.
Step 3
(Optional) Check the Skip Image Download check box and click Next to use images that are already
Step 4
downloaded (the file is already on the bootflash). Proceed to
You see the Specify Software Image(s) by Model Dialog Box shown in
Cisco MDS 9000 Family Fabric Manager Configuration Guide
15-8
Software Install Wizard Icon
Select Switches Dialog Box
Figure 15-2).
Figure 15-3).
Step 7.
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 15 Software Images
Figure 15-4.