Cisco Catalyst 4500 Series Configuration Manual page 616

power inline police
power inline police
To configure Power over Ethernet policing on a particular interface, use the power inline police
command. The no form of the command disables PoE policing on an interface.
Syntax Description
action
errdisable
log
Command Default PoE policing is disabled.
Command Modes Interface configuration mode
Command History Release
12.2(50)SG
Usage Guidelines If a port is in the errdisable state because of a PoE policing fault, enter the shut command followed by
a no shut on the interface to make the port operational again.
You can also configure inline-power errdisable autorecovery so that an errdisabled interface is
automatically revived when the errdisable autorecovery timer expires.
Examples The following example shows how to enable PoE policing and configure a policing action:
Switch(config)# int gigabitEthernet 2/1
Switch(config-if)# power inline police
Switch(config-if)# do show power inline police gigabitEthernet 2/1
Available:421(w)
Interface Admin
--------- ------ ---------- ---------- ---------- ------ -----
Gi2/1
Switch(config-if)# power inline police action log
Available:421(w)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-576
power inline police [action] [errdisable | log]
no power inline police [action] [errdisable | log]
(Optional) Specifies the action to take on the port when a PoE policing fault
occurs (the device consumes more power than it's allocated).
(Optional) Enables PoE policing on the interface and places the port in an
errdisable state when a PoE policing fault occurs.
(Optional) Enables PoE policing on the interface and, if a PoE policing fault
occurs, shuts, restarts the port, and logs an error message.
Modification
This command was introduced on the Catalyst 4500 series switch.
Used:39(w)
Oper
State State
auto on
Used:39(w)
Remaining:382(w)
Admin Oper Cutoff Oper
Police Police Power
errdisable ok 17.4
Remaining:382(w)
Chapter 2
Power
7.6