Show Redundancy - Cisco Catalyst 4500 Series Configuration Manual

Chapter 2

show redundancy

To display redundancy facility information, use the show redundancy command.
Syntax Description
clients
counters
history
states
Command Default This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1.(13)EW
12.2(31)SGA
Examples The following example shows how to display information about the redundancy facility:
Switch# show redundancy
Switch# show redundancy
4507r-demo#show redundancy
Redundant System Information :
------------------------------
Switchovers system experienced = 0
Current Processor Information :
-------------------------------
IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.2(20)EWA(3
.92), CISCO INTERNAL USE ONLY ENHANCED PRODUCTION VERSION
Copyright (c) 1986-2004 by cisco Systems, Inc.
show redundancy {clients | counters | history | states}
(Optional) Displays information about the redundancy facility client.
(Optional) Displays information about the redundancy facility counter.
(Optional) Displays a log of past status and related information for the redundancy
facility.
(Optional) Displays information about the redundancy facility state, such as disabled,
initialization, standby, active.
Modification
This command was introduced on the Catalyst 4500 series switch
Support for ISSU was introduced.
Available system uptime = 2 days, 2 hours, 39 minutes
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = Stateful Switchover
Operating Redundancy Mode = Stateful Switchover
Maintenance Mode = Disabled
Communications = Up
Active Location = slot 1
Current Software state = ACTIVE
Uptime in current state = 2 days, 2 hours, 39 minutes
Image Version = Cisco Internetwork Operating System Software
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
show redundancy
2-951