Cisco Catalyst 4500 Series Configuration Manual page 178

control-plane
control-plane
To configure the IP address of the control-plane device with which the edge device can communicate, in
the fabric domain, use the control-plane ip address auth-key key command.
Syntax Description
control-plane ip address
auth-key key
Command Default None.
Command Modes Fabric-auto-domain configuration
Command History Release
3.9.01E
Usage Guidelines Use the command to configure the control-plane device IP address and the authentication key, to allow
fabric edge devices in the fabric domain to communicate with the control-plane device .
This command enables the auto-generation of LISP (Locator ID Separation Protocol) and VRF (Virtual
Routing and Forwarding) configuration, to orchestrate the fabric overlay. The show-running
configuration command shows the virtual context configuration including the auto-generated base line
commands.
Examples
The following configuration is auto-generated when this command is run on your device:
Device(config-fabric-auto-domain)#control-plane 2.2.2.2
auth_key examplekey123
r
outer lisp
locator-set default.RLOC
ipv4-interface Loopback0 priority 10 weight 10
exit
disable-ttl-propagate
ipv4 sgt
eid-table default instance-id 0
exit
loc-reach-algorithm lsb-reports ignore
ipv4 itr map-resolver 2.2.2.2
ipv4 itr
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-140
control-plane ip address
auth-key key
Modification
This command was introduced on the Catalyst 4500-E series switch using a
Supervisor Engines 8-E and 8L-E.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Configures the IP address of the control-plane device, to which the edge
device can connect.
Configures the key to authenticate access to the control-plane device.
OL-30934-01