Cisco Catalyst 4500 Series Configuration Manual page 490

mka
mka
To apply an MACsec Key Agreement policy on an interface, and to configure MKA MACsec on a
interface using a PSK, use the mka command.
Syntax Description default-policy
policy policy name
pre-shared-key
key-chain
key-chain-name
Command Default
The default MKA policy is applied on the interface.
Command Modes Interface configuration mode
Command History Release
Cisco IOS XE 3.9.0E This command was introduced on Cisco Catalyst 4500-E with Supervisor
Examples
The following example shows how to enable the Cisco-recommended features and settings on port fa2/1:
Switch(config)# interface FastEthernet2/1
Switch(config-if)# mka pre-shared-key key-chain kc1
Switch(config-if)# exit
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-450
mka {default-policy | policy policy name {|pre-shared-key {key-chain key-chain-name}
Enables MKA MACsec using the default MKA policy on the interface.
Enables MKA MACsec using a configured MKA policy on the interface.
Enables MKA MACsec using a pre-shared key on the interface.
Modification
Engine 8-E, and on Cisco Catalyst 4500-X series switches.
Chapter 2