Show Module - Cisco Catalyst 4500 Series Configuration Manual

Chapter 2

show module

To display information about the module, use the show module command.
Syntax Description
mod
all
Command Default This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.2(25)EW
Usage Guidelines In the Mod Sub-Module fields in the command output, the show module command displays the
supervisor engine number but appends the uplink daughter card's module type and information.
If the PoE consumed by the module is more than 50 W above the administratively allocated PoE, the
"Status" displays as "PwrOver." If the PoE consumed by the module is more than 50 W above the PoE
module limit, the "Status" displays as "PwrFault."
Examples The following example shows how to display information for all the modules.
The following example shows the show module command output for a system with inadequate power
for all installed modules. The system does not have enough power for Module 5; the "Status" displays
it as "PwrDeny."
Switch# show module all
Mod
----+-----+--------------------------------------+-----------------+-----------
1
2
3
5
6
show module [mod | all]
(Optional) Number of the module; valid values vary from chassis to chassis.
(Optional) Displays information for all modules.
Modification
This command was introduced on the Catalyst 4500 series switch.
Enhanced the output of the show idprom interface command to include the
10-Gigabit Ethernet interface.
Ports Card Type
2 1000BaseX (GBIC) Supervisor(active)
6 1000BaseX (GBIC)
18 1000BaseX (GBIC)
0 Not enough power for module
48 10/100BaseTX (RJ45)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Model Serial No.
WS-X4014 JAB054109GH
WS-X4306 00000110
WS-X4418 JAB025104WK
WS-X4148-FX-MT 00000000000
WS-X4148 JAB023402RP
show module
2-891