Cisco Catalyst 4500 Series Configuration Manual page 390
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
ip local-proxy-arp
ip local-proxy-arp
To enable the local proxy ARP feature, use the ip local-proxy-arp command. To disable the local proxy
ARP feature, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
Local proxy ARP is disabled.
Command Modes
Interface configuration mode
Command History
Release
12.1(8a)EW
Usage Guidelines
Use this feature only on subnets where hosts are intentionally prevented from communicating directly
to the switch on which they are connected.
ICMP redirect is disabled on interfaces where the local proxy ARP feature is enabled.
Examples
The following example shows how to enable the local proxy ARP feature:
Switch(config-if)# ip local-proxy-arp
Switch(config-if)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-350
ip local-proxy-arp
no ip local-proxy-arp
Modification
This command was introduced on the Catalyst 4500 series switch.
Chapter 2
Advertisement
Table of Contents
